Bending processing of stainless steel plate, 5 aspects need to pay attention to!

[guidebook] : In the production and processing process of stainless steel honeycomb panels, the bending of stainless steel panels and base plates is the key difficulty.

In the production and processing process of stainless steel honeycomb panels, the bending of stainless steel panels and base plates is the key difficulty.

Bending processing of stainless steel panels, there are 5 points you must know!

1, in general, the thicker the stainless steel panel, the greater the required bending strength, and with the increase in panel thickness, when adjusting the bending equipment, the bending strength also needs to be adjusted accordingly the greater.

2, under the unit size, the greater the tensile strength of the stainless steel plate, the smaller the elongation, the greater the required bending strength and bending angle should be.

3, drawings of stainless steel plate thickness and bending radius corresponds to the case, according to experience, bending workpiece unfolding size for the right-angled edge plus minus two plate thickness, can meet the design accuracy requirements.

4, the greater the yield strength of the material, the stronger the elastic recovery. In order to obtain the 90-degree angle of the bending part, the smaller the angle of the pressure knife should be.

5, for carbon steel, the same plate thickness of stainless steel bending angle is larger, this point requires special attention, otherwise there will be bending cracks, affecting the strength of the workpiece.