Stainless steel engineering water pipe construction 3 elements, strict prevention of water leakage problems!

[guidebook] : Everyone knows the advantages of stainless steel engineered water pipes, there is no need to worry about water quality and quality, safety and health...

Everyone knows the advantages of stainless steel engineered water pipes, there is no need to worry about water quality and quality, safety and health. However, what if you encounter corrosion and leakage of stainless steel engineering water pipe ? At the same time, how to prevent stainless steel engineering water pipe leakage, let us look at the following explanation.

If the stainless steel engineering water pipe is corroded and leaking, what should I do ?

At first, the upper water pipe leaks. Check whether the rubber gasket is aging and whether the screws are loose. If there is a problem, you should close the angle valve, remove the hot and cold water pipes and find out where the relevant problem lies. If the angle valve or plumbing pipe is damaged or rusty, only replace it with a new one. Then check the water tank for leaks. If it is leaking, most of the stainless steel plates of the water tank will be damaged. It could be a leak at the connection between the top and bottom pipes of the sink. If the sink system is damaged, gaps below 2mm should be coated with waterproof putty; if the gap is less than 5mm , the plywood can be made of white iron and the sides coated with waterproof putty. If the hole is larger, replacement is strongly recommended !

How to avoid stainless steel project water pipe leakage of construction and installation precautions

1, covering and wrapping anti-corrosion materials

Even high-quality stainless steel engineering water pipe should be carefully installed, not directly with cement and concrete laying. Pipes are laid in front of cement concrete walls or floors. The outer wall of the pipe directly with anti-corrosion tape or plastic coated thin-walled stainless steel pipe wrapped; can also be wrapped with two layers of polyethylene tape or two layers of vinyl chloride tape, and then wrapped in two layers of asphalt paint with fiberglass plastic cloth to prevent corrosion, so that stainless steel engineering water pipe can withstand more serious natural corrosion.

2, equipped with the installation of compensation accessories

Laying stainless steel engineering water pipe, should also be properly set up expansion compensation components and brackets, flow brackets or behavioral brackets, in order to control the expansion of the pipe deviation or compensation.

3, pay attention to the matching of pipe fitting type and specification

Stainless steel engineering water pipe in the construction and installation process must also pay attention to the relevant accessories. Try to choose pipes and fittings from the same supplier to prevent problems such as failure to install due to different models and specifications. This is also something that requires special attention.

In many projects, stainless steel engineering water pipes are laid in exposed locations. At this time, attention should be paid to the insulation of the water pipe to avoid stainless steel engineering water pipe freezing, resulting in water supply difficulties; In addition, the transportation of stainless steel engineering water pipe should avoid collision with sharp objects, so as not to damage the pipe and cause signs of water leakage. Therefore, attention should be paid to the construction process. If there are special requirements, the pipes should be sterilized with disinfectant after installation and pressure test.